
Series C Controller Configuration and Operation Manual
14-12 Athena Controls, Inc. 900M050U00
14.9 Configuring the Remote Analog Setpoint Parameters
14.9.1 Introduction
If the card type is rASrAS, then the rASrAS (remote analog setpoint) menu is displayed. It
contains two parameters, which are described below.
14.9.2 Scaling the Input for the Remote Analog Setpoint
: Remote Analog Setpoint Scale Low (G5) and Remote Analog
Setpoint Scale High (G6)
:
SCL.L SCL.L and SCL.H SCL.H
all except 1ZC
if the card type is remote analog setpoint
–1999 to 9999 (See Note 1 below.)
scale low: –1999
scale high: 9999
Used to specify the SV represented by the lowest (SCL.LSCL.L) and
highest (SCL.HSCL.H) possible remote analog input signal.
Note 1: The range is reduced when a linear input is used and the value of the dSPLdSPL
(display) menu dEC.PdEC.P (decimal position) parameter is not 0 (zero). See 4.3.2 for more
information about the effect of a linear input on numerical ranges.
Kommentare zu diesen Handbüchern